# Engine definition. Dimensional keys state their units.
schema_version = 1
id = "yz-torque"
name = "125 / long torque chamber"
category = "Two-stroke / 125 cc"
description = "Estimated chamber geometry / same 125 cc engine"
order = 12
cycle = "two_stroke"

[two_stroke]
initial_rpm = 3000.0
starter_torque_nm = 8.0
maximum_load_torque_nm = 10.0
crankshaft_inertia_kg_m2 = 0.01
bore_mm = 54.0
carburetor_diameter_mm = 38.1
crankcase_clearance_cc = 150.0
exhaust = "racing"
exhaust_cell_length_mm = 10.0
exhaust_duration_deg = 190.0
exhaust_width_mm = 36.0
friction_bar = 0.4
friction_bar_per_mps = 0.09
friction_bar_per_mps2 = 0.0009
idle_minimum_advance_deg = -10.0
idle_slide_opening = 0.03
idle_spark_gain = 0.05
jet_scale = 1.0
main_jet_scale = 1.6
minimum_burn_s = 0.0008
needle_jet_scale = 1.0
needle_low_scale = 2.9
needle_mid_scale = 0.8
needle_off_idle_scale = 24.0
needle_quarter_scale = 1.4
needle_tip_scale = 6.5
needle_transition_scale = 9.0
needle_upper_scale = 0.76
pilot_jet_scale = 0.5475
pilot_tip_scale = 1.0
pilot_transition_scale = 1.55
rod_mm = 110.0
stroke_mm = 54.5
transfer_duration_deg = 130.0
transfer_width_mm = 50.0
trapped_compression = 8.2
chamber_sections_mm = [[188.8, 36.0, 36.0], [212.4, 36.0, 60.0], [224.2, 60.0, 105.0], [153.4, 105.0, 105.0], [247.8, 105.0, 22.0], [283.2, 22.0, 22.0]]

[ecu]
idle_control = "fixed"
idle_rpm = 3000.0
idle_max_opening = 0.3
throttle_time_constant_s = 0.0002
throttle_rate = 5000.0
rev_limit_enabled = false
rev_limit_fuel_cut_enabled = false
overrun_cut_rpm = 5000.0
overrun_resume_rpm = 3500.0
overrun_fuel_cut_enabled = false
overrun_ignition_cut_enabled = true
ignition_map = [[0, 10], [3000, 18], [6000, 24], [9000, 18], [11000, 12], [13000, 6], [15000, 2], [18000, 0]]

[vehicle]
primary_reduction = 3.368421
final_drive_ratio = 3.769231
mass_kg = 170
wheel_radius_mm = 331.3
gear_ratios = [2.384615, 1.933333, 1.588235, 1.352941, 1.176471, 1.055556]